EcoAir VpCI-337 can be safely and easily transported
for use even into remote areas.
Cortec offers corrosion-control spray can
DUBAI, September 20, 2016
Cortec, a leader in corrosion control technologies, has launched a convenient, environmentally friendly corrosion protection solution in an easy-to-use spray can powered by compressed air.
Cortec carried its eco-friendly corrosion inhibitor VpCI-337 to a whole new level of convenience and environmental consideration when it began packaging it into recyclable EcoAir VpC-337 Fogger.
On its own, VpCI-337 is a powerful biodegradable waterborne vapour corrosion inhibitor used to protect metal parts and internal void spaces with a thin, environmentally friendly self-healing film. Vapour phase Corrosion Inhibitors (VpCIs) in the fluid migrate and protect metal surfaces, resulting in time and cost savings and using a minimum amount of product.
Using bag-on-valve technology, EcoAircans are powered by compressed air and can be sprayed in any direction—even upside down—without any worries about releasing solvents, VOCs, or aerosols into the atmosphere. EcoAir VpCI-337 can be safely and easily transported for use even into remote areas without the need for electricity or special spray equipment. When the can is empty, users can simply pop the top off, remove the inner bag, and throw the remaining aluminium can directly into the recycling, avoiding costly and inconvenient disposal procedures.
VpCI-337 is consistently successful in providing protection to basic metal, metalworking, and packaging industries. In most cases, products protected by EcoAir VpCI-337 Fogger are ready-to-use—with no degreasing or stripping necessary. The metal will retain a clean, corrosion-free surface, and the thin protective film will not affect paintability, conductivity, appearance, or any other important property of metals or alloys.
EcoAir VpCI-337 is versatile for many applications:
• Void space protection
• Edge spring for coils
• Double wall spaces
• Complex internal cavities
• Deep storage of key assets
• Pipes, spools, modules
• Post-weld touch-up
In testing the performance capabilities of EcoAir VpCI-337, the Cortec lab found that an EcoAir can effectively sprays VpCI-337 a distance of approximately 40 inches (101.6 cm). On average, a full can will last for four and a half minutes of constant spraying. Coverage rate is approximately 0.3-1.0 fluid ounces (8.87-29.57 ml) per cubic foot (0.03 cu m), meaning 4-6 ounces (118.29-177.44 ml) of spray will protect a metal void space 12.7 cubic feet (0.36 cu m) in volume.
During testing, the EcoAir VpCI-337 was sprayed on carbon steel, galvanized steel, copper, and aluminium panels and found to effectively protect these metals from corrosion. The biodegradable fluid is designed to protect a variety of other metals, as well:
• Hot/cold-rolled steel
• Silicon steel
• Stainless steel
• Cast iron
Cortec’s EcoAir VpCI-337 makes corrosion protection immediate, effective, and extremely convenient to apply and discard without special environmental concerns. By packaging this biodegradable corrosion inhibitor in a recyclable can, Cortec® has created an excellent alternative both to hazardous corrosion inhibiting chemicals and environmentally damaging aerosol cans.
Cortec’s EcoAir VpCI-337 Fogger conforms to the following standard test methods: ASTM D-1735 (Water Fog Cabinet), ASTM D-1748 (Humidity Cabinet), and NACE RP0487-2000 (Selection of Rust Preventives). – TradeArabia News Service